The best time to seal your pavement is when it is still in good condition.
-Power Edge: Cutting overgrown grass along blacktop. This allows for the sealer to be applied to the edges of the driveway for a manicured finish.
-Power Clean: Wire brushing the cracks and surface of the driveway in addition to blowing off debris makes a big difference and very few companies take the time and effort.
-Heat Treat oil spots: Torch and prime with multipurpose primer which provides greater adhesion to oil spots.
-Holes / low spots: Fill with hot asphalt or cold patch depending on specific need.
-Seal Joints: Hot rubberized joint filler bonds between concrete garage apron, sidewalk, and street, preventing costly water damage.
-Patch / Seal cracks: Hot rubberized crack filler is heated to 400 degrees. Equivalent materials used on roadways. For mainline cracks 1/4 to 1 inch wide.
-
Hand apply industrial grade sealer using a prostrand brush. Sealer is 100% asphalt based emulsion. We will use a 4% tarmax additive along with 3lbs. per gallon silica sand and 1% carbon black color enhancer.
-Barricade Access: To driveway with Border Lines banner for 48 hours.
***Keeping moisture out from under your pavement is the most important maintenance item you can do to extend the life of your asphalt. Our product meets and exceeds MN Department of Transportation (DOT) specifications for roadway crack filler. |
|
Please call or provide your contact information below. |
|
